Efecto de la Redondez de la Arena Sobre el Desgaste Abrasivo A 3 Cuerpos Según la Norma Astm G65.

Fecha

Autor corporativo

Título de la revista

ISSN de la revista

Título del volumen

Editor

Compartir

Altmetric

Resumen

This Project seeks to determine the influence of local abrasives to which the machinery is exposed, for this it is necessary to find reference values ​​of national type where SILICE 20/40 sand and foreign sand Ottawa 50/70 AFS will be used in abrasive wear tests under parameters of the ASTM G65 standard. In the first stage there will be a sample preparation, sieve granulometry determining the morphological characteristics of the two types of sands defining the uniformity coefficient, roundness coefficient, humidity percentage and shapes. In the second stage, the operation of the equipment will be validated and calibrated according to procedure B of the ATSM G65 standard. In addition, variables such as humidity, abrasive flow, engine speed, force exerted on the specimens will be determined, as well as the dimensions of the and the number of tests required for the study, abrasive wear tests will also be carried out with an AISI 1020 steel and an anti-wear steel. In the third stage, the analysis and comparison of abrasive wear, optical microscopy and stereoscopy traces will be made on the two types of specimens, by means of the use of the most appropriate statistical tool, which will allow to find the differences and the correlation between the types of tests, in addition to the reference values ​​of abrasive wear for the SILICE MALLA 20/40 national sand, finally a correction factor will be formulated for the use of Sandblasting sand in abrasive wear tests.

Descripción

El presente Proyecto busca determinar la influencia de abrasivos locales a los que está expuesta la maquinaria, para ello es necesario hallar valores de referencia de tipo nacional donde se utilizará arena SILICE 20/40 y arena extranjera Ottawa 50/70 AFS en ensayos de desgaste abrasivo bajo parámetros de la norma ASTM G65. En la primera etapa habrá una preparación de muestras, granulometría por tamizado determinando las características morfológicas de los dos tipos de arenas definiendo el coeficiente de uniformidad, coeficiente de redondez, porcentaje de humedad y formas. En la segunda etapa se validará y calibrará el funcionamiento del equipo según el procedimiento B de la norma ATSM G65, además se determinarán las variables como humedad, flujo abrasivo, velocidad del motor, fuerza ejercida sobre las probetas al igual que las dimensiones de las estás y el número de pruebas necesarias para el estudio, también se realizarán los ensayos de desgaste abrasivo con un acero AISI 1020 y un acero antidesgaste. En la tercera etapa se hará el análisis y comparación de las huellas de desgaste abrasivo, microscopia óptica y estereoscopia sobre los dos tipos de probetas, mediante el uso de la herramienta estadística más apropiada, la cual permitirá hallar las diferencias y la correlación entre los tipos de ensayos, además de los valores de referencia de desgaste abrasivo para la arena nacional SILICE MALLA 20/40, finalmente se formulará un factor de corrección para el uso de arena Sandblasting en ensayos de desgaste abrasivos.

Palabras clave

Abrasivos, Arena, Estereoscopio, Granulometría

Materias

TECNOLOGÍA MECÁNICA - TESIS Y DISERTACIONES ACADÉMICAS , ARENA - PRUEBAS , RESISTENCIA DE MATERIALES , GRANULOMETRÍA

Citación