Diseño e implementación de un control de fuerza para un sistema de sujeción al centro de mecanizado Leadwell V-20i

Abstract

This document presents the design and implementation of a control system for a clamping press that can be used in the machining LEADWELL V20-i, belonging to the laboratories of the University District Francisco José de Caldas. In the first place, the system of used in the LEADWELL V20-i machining center and the complications of subjection that were presented. Next, the design of the control of force proportional to the fastening system, which is based on the use of an Arduino board and the LabVIEW monitoring interface with its LIFA extension. In addition, information flow diagrams are presented. Continuing with the development, the force generation device was selected, the selection of the Arduino card, and finally the programming. At the end you will find the implementation of the design done and the tests carried out in order to make the necessary adjustments, accompanied by of the respective conclusions and citations bibliographies.