Bohórquez Ávila, Carlos ArturoGuerrero Enciso, Crhistian CamiloSalazar Castellanos, Jehisson Fernando2017-01-052017-01-052015-09-21http://hdl.handle.net/11349/4792En este trabajo se analiza el efecto sobre la resistencia al desgaste abrasivo de tres tratamientos térmicos en un acero SAE 1020. El estudio sobre el material, se llevó a cabo desde su estado base o de entrega, con un temple a temperaturas intercríticas empleando dos medios de enfriamiento, seguido de un tratamiento criogénico y finalmente revenido a diferentes tiempos. Los resultados muestran que hay un mínimo aumento en la resistencia al desgaste abrasivo al realizar un temple a la mayor temperatura o A3 empleando agua como método de enfriamiento y en cualquier tiempo de revenido.In this study the effect on resistance to abrasive wear of three heat treatments is analyzed in a steel SAE 1020. The study of the material was carried out from its base state or delivery, hardened to intercritical temperatures using two cooling ways, followed by a cryogenic treatment and finally tempered at different times. The results show that there is a minimal increase in abrasive wear resistance by performing hardening at the highest temperature or A3 using water as the cooling way and in any tempering time.pdfspaAtribución-NoComercial-SinDerivadas 4.0 Internacionalhttp://creativecommons.org/licenses/by-nc-nd/4.0/Temperaturas intercríticasCriogeniaDesgaste abrasivoTratamientos térmicosInfluencia del tiempo de revenido en la resistencia al desgaste abrasivo de un Acero AISI 1020 templado desde temperaturas intercríticas seguido de un tratamiento criogénicoinfo:eu-repo/semantics/openAccessTempering influence of time on the abrasive wear resistance of AISI 1020 steel, hardened from intercritical temperatures followed by a cryogenic treatmentAbrasive WearwIntercritical temperaturesAbierto (Texto Completo)info:eu-repo/semantics/bachelorThesis